Changing front speakers

Tools required; T30 Torx driver, philips driver, large flat screwdiver/trim remover, small pick or electritions screwdriver, wire cutters, silicone sealant. Parts required; Speaker mounting collars (13cm, 16.5cm or home made), sound deadening material

1		Lever out small reflector
2		Undo 4 T30 screws
3		Pull off tweeter cover
4		Carefully lever of door panel starting at bottom, protect door with tape (be carefull at the top not to bend the lock pin)
5		Undo 4 screws securing speaker & unplug
6		Unclip tweeter & unplug (if being changed)
7		If fitting 16.cm speakers, fit 16.5cm pods using lower 2 original screws & drill 2 top mounts
8		Fit new speaker (& crossover if required)
9		Fit tweeter if being changed (double sided sticky or drill & angle)